Motor is in vertical position to reduce dimensions at rear:
the transmission is made by means of a worm drive gearbox in oil bath (1:40 ratio). Large circular support base:
it offers an ample surface to support piece during cutting cycle and allows to reach a high grade of precision in cutting perpendicularity. It rotates over a tempered ball track giving maximum smoothness during rotation. Adjustable bow position:
by means of a key on eccentric bushing for 90° cuts, by means of mechanical stops at 45° right & 45-60° left. Blade guides:
they drive the blade sliding by means of widia hard metal plaques with bearings on eccentric bushings. Adjustable manual vice:
It can be positioned lengthwise along the entire machine base. Vice features: rapid closing, closing hand wheel, flat adjustable gib plate. Retractable and adjustable vice shoulders:
Pushing back the retractable vice shoulder, it is possible to reach the maximum cutting capacity (420 x 190 mm, at 90°). The adjustable vice shoulder allow always to obtain a precise alignment. Blade tightening device:
this is the best solution for a constant and uniform blade tension. Blade lubrication cooling system:
with electric pump and two adjustable taps placed on blade guides. Control panel:
located in an easily accessible position with ON/OFF switch, cutting speed selector (2 speeds), MANUAL/DYNAMIC cutting selector (for machines with Newton device), emergency push button to cut off the power to the motor in case of emergency. Blade start switch:
with 'man present' guard. The safety switch for blade drive is guarded by a cover against accidental start-up. It works in low voltage. The hinged bow:
is moved on a support with conical bearings.
{"capacity":{"Swing over bed":{"Value":"400mm","Inch":"15.7\u2033"},"Swing over cross slide":{"Value":"246mm","Inch":"9.6\u2033"},"Height of centres":{"Value":"195mm","Inch":"7.7\u2033"},"Swing in gap":{"Value":"585mm","Inch":"23\u2033"},"Gap width f...
"The SH51\/ 51Y Series of CNC Lathes feature not only a high rigid structure but also multiple functions for Eccentric and Tool-Traveling \/\u00a0Turning."
